Please use this identifier to cite or link to this item:
|Type:||Artigo de periódico|
|Title:||Effect of Photoactivation Mode on the Hardness and Bond Strength of Methacrylate-and Silorane Monomer-based Composites|
|Abstract:||Purpose: To evaluate the Knoop hardness (KH) and the bond strength (BS) at the tooth/restoration interface of conventional methacrylate-(Filtek Supreme) and silorane-based (Filtek P90) composites photoactivated by different methods using an LED Freelight 2. Materials and Methods: Bond strength was tested in a universal testing machine by the "push-out" test in restored cavities measuring 2 x 1.5 x 2 mm with a C-factor of 2.2, prepared in 60 bovine teeth. To restore the cavities, the respective adhesive system of each composite was used (Single Bond 2 and P90 system adhesives). The composites were photoactivated by 3 different methods: continuous light: 40 s at 1000 mW/cm(2); soft-start: 10 s at 150 mW/cm(2) + 38 s at 1000 mW/cm(2); pulse delay: 5 s at 150 mW/cm(2), followed by a 3-min wait (without photoactivation) and 39 s at 1000 mW/cm(2). Before the push-out test was performed, the KH was analyzed at the top and bottom of the restorations. Data were statistically anaylzed using ANOVA and Tukey's test. Results: The photoactivation methods produced no differences in BS or KH in the same composite, while Filtek P90 (28.0 MPa) showed higher BS values than Filtek Supreme (22.3 MPa) and a lower KH. Conclusion: The composite Filtek P90 was capable of increasing bond strength, but presented lower Knoop hardness.|
|Editor:||Quintessence Publishing Co Inc|
|Citation:||Journal Of Adhesive Dentistry. Quintessence Publishing Co Inc, v. 15, n. 1, n. 33, n. 39, 2013.|
|Appears in Collections:||Unicamp - Artigos e Outros Documentos|
Files in This Item:
There are no files associated with this item.
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.