Please use this identifier to cite or link to this item:
Type: Artigo
Title: Effect of light polymerization time, mode, and thermal and mechanical load cycling on microleakage in resin composite restorations
Author: Soares, G. P.
Marchi, G. M.
Ambrosano, G. M. B.
Lovadino, J. R.
Correr-Sobrinho, L.
Lima, D. A. N. L.
Aguiar, F. H. B.
Abstract: This study evaluated the effect of polymerization mode and time and thermal and mechanical loading cycling (TMC) on microleakage in composite resin restorations. One hundred and eighty cavities were prepared and randomly divided according to the light curing time (20, 40, or 60 s), modes (quartz-tungsten-halogen (QTH)-420 mW/cm(2), LED 2 (2nd degree generation)-1,100 mW/cm(2), or LED 3 (3rd degree generation)-700 mW/cm(2)), and TMC. Following standard restorative procedures, the samples were prepared for analysis in an absorbance spectrophotometer. All results were statistically analyzed using the three-way ANOVA and Tukey test (p a parts per thousand currency signaEuro parts per thousand 0.05). The results revealed that the groups QTH and LED 3 submitted to TMC showed higher microleakage than those that were not submitted to TMC. Only for LED 3, 60 s showed higher microleakage than 20 s. For LED 2 and QTH, there were no differences between the times. QTH showed lower microleakage means than LED 2, when photoactivated for 20 s, without TMC. When photoactivated for 60 s, QTH showed lower microleakage means than LED 3, for the groups with or without TMC. It was concluded that TMC, the increase in polymerization time, and the irradiance were factors that may increase the marginal microleakage of class II cavities
Subject: Resinas compostas
Country: Reino Unido
Editor: Springer
Rights: Fechado
Identifier DOI: 10.1007/s10103-012-1244-7
Date Issue: 2014
Appears in Collections:FOP - Artigos e Outros Documentos

Files in This Item:
There are no files associated with this item.

Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.