Please use this identifier to cite or link to this item: http://repositorio.unicamp.br/jspui/handle/REPOSIP/197210
Type: Artigo de periódico
Title: Effect Of Surface Treatments And Bonding Agents On The Bond Strength Of Repaired Composites.
Author: Cavalcanti, Andrea Nóbrega
De Lima, Adriano Fonseca
Peris, Alessandra Rezende
Mitsui, Fabio Hiroyuki Ogata
Marchi, Giselle Maria
Abstract: An adequate repair procedure depends on high bond strength between the existing composite and the new composite. To evaluate the effect of surface treatments and bonding procedures on the bond strength of repairs performed 24 hours after composite polymerization. Composite specimens were stored in distilled water at 37 degrees C for 24 hours. Specimens were allocated into 12 groups (N=10) according to the combination of surface treatment (none, air abrasion, diamond bur) and bonding procedure (none, Single Bond after H(3)PO(4) cleansing, Clearfil SE Bond after H(3)PO(4) cleansing, Clearfil SE Bond without H(3)PO(4) cleansing). The ultimate tensile strength (UTS) of the composite was tested in nonrepaired specimens. Twenty-four hours after repair, specimens were sectioned into three slabs and trimmed to an hourglass shape (1 mm(2) area). Slabs were tested under tension and mean bond strengths analyzed with two-way analysis of variance/Tukey and Dunnett tests (alpha=5%). Two groups resulted in repair bond strengths similar to composite UTS: air abrasion combined with Clearfil SE Bond after H(3)PO(4) cleansing, and air abrasion combined with Clearfil SE Bond without H(3)PO(4) cleansing. Combinations of surface treatments and bonding procedures were not statistically different. When repair procedure was performed 24 hours after composite polymerization, different combinations of surface treatments and bonding procedures affected repair bond strength similarly. There was no statistical difference between the repair bond strength of groups air-abraded and bonded with the self-etching system and composite UTS. Only air abrasion associated with a self-etching system provided repair bond strength comparable to composite UTS.
Subject: Air Abrasion, Dental
Composite Resins
Dental Bonding
Dental Etching
Dental Prosthesis Repair
Dental Restoration, Permanent
Dental Stress Analysis
Phase Transition
Resin Cements
Surface Properties
Tensile Strength
Tooth Preparation
Citation: Journal Of Esthetic And Restorative Dentistry : Official Publication Of The American Academy Of Esthetic Dentistry ... [et Al.]. v. 19, n. 2, p. 90-8; discussion 99, 2007.
Rights: fechado
Identifier DOI: 10.1111/j.1708-8240.2007.00073.x
Address: http://www.ncbi.nlm.nih.gov/pubmed/17374114
Date Issue: 2007
Appears in Collections:Unicamp - Artigos e Outros Documentos

Files in This Item:
File SizeFormat 
pmed_17374114.pdf155.08 kBAdobe PDFView/Open


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.